9784 Hollow-Wall Mounting Unit
Material included: three #10 toggle muts with 3" long stainless steel over head machine screws.
Installation:
Position grab bar on wall and mark flange hole locations.
Drill 1/2" holes for toggle nuts and secure grab bar with screws provided.

9786 Concealed Stud Backing Mounting Kit
Material included: three #10 x 2 1/2" long oval head sheet metal screws.
Installation:
Provide concealed backing at grab bar anchor points (backing should comply with local building codes). Drill 9/64" diameter pilot holes and secure grab bar with screws provided.
Note: Tamper proof screws available at extra charge.

9788 Solid Masonry Mounting Kit
Material included: three expanding metal sleeves with three #10 x 1 1/4" long oval head machine screws.
Installation:
Position grab bar on wall and mark flange hole locations. Drill 3/8" diameter holes 1" deep at hole locations. Drive sleeves into holes and secure grab bar to wall with screws provided.
Note: Tamper proof screws available at extra charge.

9790 Solid or Block Wall Anchor Kit
Material included: three plastic anchor sleeves with three #10 x 2" long stainless steel oval head screws.
Installation:
Position grab bar on wall and mark flange hole locations. Drill 1/4" diameter holes 2 1/2" deep at hole locations. Drive in plastic anchor sleeves flush with wall and secure grab bar with screws provided.
Note: Tamper proof screws available at extra charge.

9792 One Side Partition Mounting Kit
Material included: one 3 1/8" dia. stainless steel back plate with three threaded stand-offs., and three stainless steel oval head machine screws and three acorn nuts.
(Specify partition thickness).
Installation:
Position grab bar on partition wall and mark flange screw hole locations. Drill 3/16" diameter holes through partition wall at hole locations. Secure grab bar to back plate with screws and nuts provided.
Note: Tamper proof screws available at extra charge.

9794 Back to Back Partition Mounting Kit
Material included: three threaded sleeves (specify partition thickness) and six stainless steel oval head machine screws.
Installation:
Position grab bar on partition wall and mark flange hole locations. Drill 5/16" clearance holes through partition and attach grab bar with expanding threaded sleeves and screws provided.
Note: Tamper proof screws available at extra charge.

Sizes
18", 24", 30", 36", 42", 48', 48" x 36"

9605:
Same as above with non lsip surface.

Sizes:
Same as above

Sizes
24", 36", 42", 48".

9704:
18 ga. Grab Bar 1 1/2" O.D.

Sizes:
24", 36", 42", 48"